11PH
2. P
D
RODUCT
ESCRIPTION
The pulse nutsetter/screwdriver features
-
stall torque shut-off,
-
alternative air inlet on top. If the top air inlet is used the screwed
plug <13> must be screwed and sealed in the air inlet on the pistol
grip.
-
trigger-start with soft-start valve,
-
available with two different pistol grip sizes,
-
lockable torque adjustment accessible from the outside,
-
reversible, RH and LH operation,
-
noise below 74 dB (A) when idling,
2
-
vibration below 1.0 m/s
when pulsing
3. T
A
ORQUE
DJUSTMENT
Separate the tool from the air supply.
-
The torque is set by throttling the exhaust.
-
Loosen the set bolt <10> with a key (size 2).
-
The torque is adjusted by turning the throttle exhaust in direction
"+" or "-" as needed.
-
First turn the throttle exhaust to "-" to achieve the minimum
adjustment.
-
Then adjust the desired torque by turning to "+"
-
After the adjustment, lock the throttle exhaust by fastening the set
bolt clockwise.
Throttle exhaust for torque adjustment
(key size 2; Order-No. 920001)
Sample adjustment:
1. Bolt M6 8.8 = 10 Nm
2. Torque adjustment about 2,5 turns / exhaust air throttle
(about 30 marks on the scale)
<..>/<..>
=
see 7. Spare Parts Exploded View and Ordering List
<..> Spare parts index for the
8
4. I
NSPECTION AND
To prevent downtime, regularly
-
check the oil level of the pulse unit,
-
regularly replace the oil level of the pulse unit <39>/<70> every
500 operating hours or at least every 12 months, the set of seals
<103> must be replaced.
5. W
...the torque is too low?
- Is the throttle exhaust adjusted correctly?
- Is the flow pressure too low?
- Is the reverse button not in one of its end positions?
- Is the inlet screen dirty?
- Is the muffler dirty?
- Is sufficient oil in the pulse unit?
Set bolt <10>
1/4" version / <..> Spare parts index for the
P1641E 11/99
M
AINTENANCE
I
...
HAT TO DO
F
Turns of the exhaust air throttle <7>
1/4" version
CLECO