Uline H-5221 Manual Del Usuario página 4

TOOL REQUIRED
Cap Nut
x 3
Reflector
Spacer
x 3
1. Attach post with
burner assembly
onto heater housing
using four 3/16"
stainless steel screws.
(See Figure 1)
2. Attach ring weight
to base using four
20mm bolts. (See
Figure 2)
PAGE 4 OF 27
Phillips Screwdriver
(not included)
Washer
x 6
Figure 1
Figure 2
PARTS
Nut x 3
20mm Bolt
x 4
ASSEMBLY
3. Put three reflector
spacers into the
holes in the emitter.
Use three nuts to
hold the reflector
spacers inside of
the emitter. Attach
emitter to burner
assembly using four
stainless steel screws.
(See Figure 3)
4. Insert ends of wire
guard into holes
in post with burner
assembly. (See
Figure 4)
Wrench x 1
3/16" Stainless
Steel Screw
x 8
Figure 3
Figure 4
1220 IH-5221