Uline H-5221 Manual Del Usuario página 6

PORTABLE HEATER LOCATION
1. This portable heater is intended for outdoor use only.
Always ensure adequate fresh air ventilation.
2. Always maintain
proper clearance
to combustible
materials at a
minimum of 24
inches from the top
and 36 inches from
the sides.
3. Place the heater on
a strong and stable
table.
4. Never operate
the heater in
an explosive
atmosphere, like in areas where gasoline or other
flammable liquids or vapors are stored.
To check for a leak:
1. Make 2-3 oz. leak check solution (one part liquid
dishwashing detergent and three parts water).
2. Apply several drops of solution where regulator
connects to cylinder and to all hose and valve
connections
3. Make sure all patio heater and light valves are OFF.
4. Turn cylinder valve ON.
If bubbles appear at any connection, there is a leak.
1. Turn cylinder valve OFF.
2. If leak is at regulator/cylinder valve connection:
Disconnect, reconnect and perform another leak
check. Apply the soapy solution to all hose and
valve connections. If you continue to see bubbles
after several attempts, cylinder valve is defective
and should be returned to cylinder's place of
purchase.
3. If leak is at hose/regulator connection,
this part is defective and you should contact Uline
Customer Service for replacement.
If NO bubbles appear at any connection, the
connections are secure.
NOTE: Whenever gas connections are loosened
or removed, you must perform a complete leak
test.
PAGE 6 OF 27
OPERATION
CEILING
24 in.
36 in.
DANGER! CARBON MONOXIDE HAZARD.
For outdoor use only. Never use inside house,
or other unventilated or enclosed areas. This
heater consumes air (oxygen). Do not use
in unventilated or enclosed areas to avoid
endangering your life.
CAUTION! Do not attempt to operate until you
have read and understand all general safety
information in this manual and all assembly
is complete and leak checks have been
performed.
BEFORE TURNING GAS SUPPLY ON:
1. Your heater was designed and approved for outdoor
use only. Do NOT use it inside a building, garage or
any other enclosed area.
2. Make sure surrounding areas are free of
combustible materials, gasoline and other
flammable vapors or liquids.
3. Ensure that there is no obstruction to air ventilation.
Be sure all gas connections are tight and there are
no leaks.
4. Be sure the cylinder cover is clear of debris. Be
sure any component removed during assembly or
servicing is replaced and fastened prior to starting.
BEFORE LIGHTING:
1. Heater should be thoroughly inspected before
each use and by a qualified service person at least
annually. If relighting a hot heater, always wait at
least 5 minutes.
2. Inspect the hose assembly for evidence of excessive
abrasion, cuts or wear. Suspected areas should be
leak tested. If the hose leaks, it must be replaced
prior to operation. Only use the replacement hose
assembly specified by manufacturer.
WARNING! FOR YOUR SAFETY.
Be careful when attempting to manually ignite
this heater. Holding in the control knob for
more than 10 seconds before igniting the gas
will cause a ball of flame upon ignition.
TURNING THE HEATER ON
1. Turn on the valve on the gas supply cylinder
completely.
2. Firmly press down and turn the variable control knob
approximately 90° counterclockwise.
3. Press down the variable control knob and hold for
20 seconds. While holding down the variable control
1220 IH-5221