7 • ESYLUX MANUFACTURER'S GUARANTEE
ESYLUX products are tested in accordance with applicable
regulations and manufactured with the utmost care. The guarantor,
ESYLUX Deutschland GmbH, Postfach 1840, D-22908 Ahrensburg,
Germany (for Germany) or the relevant ESYLUX distributor in your
country (visit www.esylux.com for a complete overview) provides a
GB
guarantee against manufacturing/material defects in ESYLUX
devices for a period of three years from the date of manufacture.
This guarantee is independent of your legal rights with respect to
the seller of the device.
The guarantee does not apply to natural wear and tear, changes/
interference caused by environmental factors or damage in transit,
nor to damage caused as a result of failure to follow the user or
maintenance instructions and/or as a result of improper installation.
Any illuminants or batteries supplied with the device are not
covered by the guarantee.
The guarantee can only be honoured if the device is sent back with
the invoice/receipt, unchanged, packed and with sufficient postage
to the guarantor, along with a brief description of the fault, as soon
as a defect has been identified.
If the guarantee claim proves justified, the guarantor will, within a
reasonable period, either repair the device or replace it. The
guarantee does not cover further claims; in particular, the guarantor
will not be liable for damages resulting from the device's
defectiveness. If the claim is unfounded (e.g. because the guarantee
has expired or the fault is not covered by the guarantee), then the
guarantor may attempt to repair the device for you for a fee,
keeping costs to a minimum.
12
TECHNICAL DATA
BATTERY OPERATION
BATTERY LIFE
SIGNAL VOLUME
RELATIVE HUMIDITY
OPERATING TEMPERATURE RANGE
APPROVAL
CPD NUMBER
DOP-NR.
COLOUR
MEASUREMENTS
Technical and design features may be subject to change.
In-built 3-volt FDK CR17335 lithium battery
10 years if used as intended
85 dB/3m
10 % - 95 % non-condensing
0 °C to +55 °C
EN 14604:2005/AC:2008
0786-CPD-21108
DK00489800
white, similar to RAL 9010
Ø 106 mm, height: 42 mm