Footswitch; Factory Reset - Hughes & Kettner Black Spirit 200 FLOOR Manual De Instrucciones

Black Spirit 200 Floor – Manual 1.0
7.4 Assigning a remote controlled function
(controller number) to the Control 1 and
Control 2 inputs
You can assign different controller numbers to the Control 1 and 2 ports
and use connected footswitches or expression pedals to adjust settings
in real time. See the MIDI implementation chart/controller list above
and the assigned functions for more on this. As you can gather from this
table, controller number 007 adjusts volume, preferably via an expression
pedal. A footswitch can serve to switch Boost on and off via controller
number 064.
Setting a MIDI value to 0 by switching a connected footswitch to the off
position or moving an expression pedal to the heel-down position is the
same thing as turning a knob to the far left or setting a button to the off
position. Setting a MIDI value to 127 by switching a connected footswitch
to the on position or flooring an expression pedal to put it in the toe-
down position and is the same thing as turning a knob to the far right or
setting a button on the amp to the on position. There is one exception to
this rule:
The volume level stored with the preset always determines the volume
control range's upper limit. Let's say you stored a volume level with the
knob set to the 12 o'clock or center position. In that case, you will only
be able to adjust the volume up to that center-position level. The idea
behind this is that when playing live, this lets you adjust the volume of a
preset just like you would with a conventional volume pedal.
Heads up: The amp ignores the expression pedal's position when you
switch to another preset. For example, if you give the expression pedal a
nudge to back off the volume level and then call up another preset, the
amp's volume will jump to the level stored in the preset. If you wish to
remote control the overall volume across all presets Black Spirit 200 Floor
– in other words, if you want to control the Master knob from afar – we
recommended inserting an analog, low-impedance volume pedal into the
FX loop.
• Control 1: To access Edit mode, press and hold the Tap and D buttons
simultaneously until the display shows the controller number and the
dot behind the second digit starts flashing. You can now change the
controller numbers using the Up/Down buttons. Store the selected
controller number by pressing D. The dot stops flashing, and the amp
returns to normal mode.
• Control 2: Press and hold Tap and C until the display shows the
controller number and the dot behind the first digit starts flashing,
then release the buttons. Change the controller number just as you
would for Control 1. Store and quit Edit mode by pressing the C
button.
12
Expression Pedal
Sleeve
Ring

Footswitch

Sleeve

7.5 Factory reset

A factory reset is a seldom-needed feature. Nonetheless, please read these
instructions carefully to ensure you don't accidentally delete your presets.
You can perform a factory reset by doing the following: Press and hold
both Store and FX Access for three seconds while switching the amp on.
Both buttons will flash to indicate the factory reset. Wait until the channel
LEDs stops flashing, at which point the amp will return to normal operating
mode. You will have to re-connect Bluetooth after a factory reset. See
chapter 6 for more on this.
Caution: Please note that this procedure is a last-resort option. It will
reset all settings, including the presets and the basic MIDI configuration.
min.
25 - 50 k linear
max. min.
max.
Tip Ring Sleeve
Tip
Tip Sleeve
Tip