BGS technic 3382 Manual De Instrucciones página 8

2. Connect the RED jump starter terminal with the Battery
positive and BLACK jump starter terminal with Battery
negative.
3. Connect the connector (EC5) of the jump starter cable with
the jump starter socket on the device.
1. RED terminal on
2. Green LED on: start the engine.
3. Green LED flashes: engine started successfully (do not leave the
device connected for more than 5 seconds).
4. Red LED flashes slowly: the battery capacity of the jump starter is
too low or the engine was not started in time.
Charge the jump starter or reconnect according to step 1 and start
the engine.
5. Red LED flashes quickly with buzzer: reverse polarity or short
circuit, reconnect according to step 1 and start the engine.
6. "Boost" is only pressed if the green LED dosn´t light up when
connected correctly. Press the "Boost" - button for 3 seconds and
when the green LED lights up, you can start the engine.
Please note, that spark protection, reverse polarity protection and
short circuit protection is deactivated after press the "Boost"
button.
4. As soon as the engine starts to run, disconnect the jump
starter cable from the device and remove the jump starter
terminals from the vehicle battery.
CHARGING 5V USB DEVICES
1. Select the USB charge cable.
Connect the USB connector with the 5V USB output socket.
2. Connect the charge cable (Micro USB plug or "Lightning"
plug for Apple) with the end device to be charged, e.g.
connect tablets, Smartphones, etc.
3. Press the button: the device switches on and the charging
process begins. The device connected such as tablet,
smartphone, etc. is charged.
SUPPLY OF 12V / 19V DEVICES
The device can operate / charge 12V / 19V DC end devices with a
current consumption of 10 amps or less. Connect the device with
optional accessories to the 12V or 19V connection.
Press the ON / OFF switch to start the power supply. If the
connection is disconnected, the jump start switched automatically
off.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
+ –
and BLACK terminal on
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
Clamp (+)
Green LED
EC5 -
Clamp (-)
Connector
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Boost-
button
Red LED