Cooling; Supply Air Limit Temperature; Night Mode; Temperature Control Probe - LMF Clima LC2 Manual De Uso

6.9. Cooling

The cooling element s activated by set point and a differential
The 3 point valve is regulated proportionally on th e set point

6.10. Supply air limit temperature

When the remote display sensor is enabled as regulation probe, the supply air sensor is used to avoid temperature
too high during heating or too low during cooling an d the valves are closed in proportionally way

6.11. Night mode

Nigh mode is used to reduce the fans speed during the night in order to reduce the noise level
When the night mode is active the symbol
If the weekly program mode is active, night mode has the priority on fan speed reducing it at value

6.12. Temperature Control probe

The control is based on the air supply temperature probe, using the parameter it is possible to switch the control on
the terminal probe or to an additional probe (not supplied) to be connected to the terminal.
The following three cases are then possible:
1) control on the supply probe

(password) 1




= 0 (Supply temperature probe)
Attention
With a control on the supply, please make sure that the supply probe is placed downstream all the additional de vices
such as water heat exchangers and electric batteries.
2) control on the probe inside the terminal

(password) 1




= 1 (Terminal control probe)
3) control on the additional probe (not supplied) to be connected to the terminal
Connect the probe to the terminals AIR2 as shown:
Only after connecting the probe to the terminals AIR2, modify the parameter:

(password) 1




= 1 (Control probe on terminal AIR2)
firmware 1.03
Electronic Control "LC2" User Manual
is blinking.
NTC 10k - 25°C
Rev.11
EN

.
EN 11/ 15