Publicidad
Idiomas disponibles
Idiomas disponibles
Before using your new Steren´s product, please read this instruction manual to prevent any damage.
The instructions of this manual are for reference about the product.
There may be differences due to updates.
Please check our web site (www.steren.com) to obtain the latest
version of the instruction manual.
HIGHLIGHTS
The 4" B&W monitor with night vision camera doorphone system is perfect for
identifying who's ringing at your door- day or night - and avoid being taken by
surprise. It includes a SD card slot, which stores a picture of the person who is ringing
the bell. The camera allows a 30° inclination adjustment, easily adapting to any wall
surface by its fixing plate.
- 4" Flat CRT screen, electric lock button control, auto off, infrared night vision camera,
rain-resistant camera, Bi-directional conversation system,snap shot.
CONTROLS
INTERCOM
Screen
Unlock
SD cad slot
Volume
CAMERA
Microphone
Infrared light tube
Camera lens
Loud speaker
INSTALLATION
CAMERA
1. Select the place where you wish to install the camera.
It is recommended that you install the camera at a 4.5
– 5 feet height.
2. Move the camera adjust switch up and down in
order to set the viewable area.
3. Place the connection cable (white cable with four
colored strands at each end) on the rear side of the mounting base.
Connect them according to the following chart:
4. Connect the two cables (black/
red) to an electric door latch (not
included) in order to be able to open
a door.
5. Set the mounting base to the de-
sired height and place two screws in
order to fix it firmly to the wall.
INTERCOM
It is recommended that the intercom to be placed
at a 4.5-5 feet height.
1. Fix the metal plate using screws at the desired
height.
2. On the intercom, connect the camera cables
according to the colors on the chart.
3. Set the intercom on the previously installed
metal base.
4. Connect the power cord to an electrical outlet,
near the intercom.
5. Insert a SD card on the correspondent slot.
CONNECTION DIAGRAM
POWER
ADAPTER
INTERCOM
Loud speaker
Power
Light
Monitor
Playback
Handset
Receiver
connecting wire
Contrast
SD cad slot
Angle switch
lower
upper
AB
CD
AV
B+
Call button
CONECTOR
A
B
C
D
INTERCOM
CABLE COLOR
1
BLACK
3
WHITE
4
YELLOW
5
1
3
4
A
5
V
B+
CAMERA
ELECTRIC DOOR LOCK
INDOOR SECTION
1. When the visitor press the call button, you will hear a ring in the indoor device.
Then you can view the image in the screen and a snap shot is stored on the SD card
at the same time.
2. Pick the headset up to talk with the visitor. The system will turn off after you hang
up. If you don't answer, the system will turn off automatically after 30 seconds.
3. After to talk with the visitor, press the unlock button if you want to open the door,
automatically.
4. If you want to see what happen outside, press "Monitor".
5. Move the contrast button to set the contrast level of the screen.
6. Set the volume level in accord to your needs.
OUTDOOR SECTION
1. The visitor press the "Call" button to communicate with the
people inside of home or office.
2. Visitor can talk through the microphone.
3. The infrared photographing system can display a clear
image of the visitor, even at night.
DOWNLOADING SNAP SHOTS
1. Remove the SD card and insert it into a card reader in the
computer.
2. Locate the "DCIM" folder. Pictures are stored into it.
SET DATE/HOUR
1.- Press and hold PLAYBACK button until see the date/hour.
2.- Press PLAYBACK to select a number, UNLOCK is up key, MONITOR button is
down key.
3.- To save changes only press and hold again PLAYBACK button until turn the
screen off. If you want to turn the CCTV-045 on only press POWER.
REVIEW PICTURES
When you press the PLAYBACK button on indoor monitor, the last picture will be
showed on the screen, press UNLOCK button you can turn back to the previous
pictures and MONITOR button will be DELETE function.
THERE IS NO IMAGE IN THE INTERCOM
-If the camera receives direct sunlight you will get a bad image, use one of the pieces
as shown in the diagrams 1A (to cover) or 2 (to give an 45° angle) to prevent exposure.
-Check if the contrast is very low, if so, adjust the level using the knob to see a better
image.
-Read the "Installation" section and check connections.
I CAN´T CAPTURE IMAGES
If you see the "NO card" message when the CALL button is pressed, it means that
there is no SD card on the slot. In this case, insert and firmly press the card into the
intercom's slot.
MONITOR
Input: 13.5 V - - - 1.5A
Consumption:
20W in operation, 1W stand-by
lower
AC/DC CONVERTER
upper
Input: 100-240V~50-60Hz 600mA
Output: 13.5V - - - 1.5A
Product design and specifications are subject to change without previous notice.
COLOR DEL
CABLE
NEGRO
BLANCO
AMARILLO
This Steren product is warranted under normal usage against defects in workmanship and materials to the original purchaser for one year from
ROJO
the date of purchase.
1.- This warranty card with all the required information, invoice or purchase ticket, product box or package, and product, must be presented when
warranty service is required.
2.- If the product stills on the warranty time, the company will repair it free of charge.
3.- The repairing time will not exceed 30 natural days, from the day the claim was received.
4.- Steren sell parts, components, consumables and accessories to customer, as well as warranty service, at any of the addresses mentioned later.
If the product has been damaged by an accident, acts of God, mishandling, leaky batteries, failure to follow enclosed instructions, improper repair by
unauthorized personnel, improper safe keeping, among others.
a) The consumer can also claim the warranty service in the purchase establishment.
b) If you lose the warranty card, we can reissue it, if you show the invoice or purchase ticket.
Name of the retailer ____________________________________
RED
Address _____________________________________________
Product ______________________________________________
Brand _______________________________________________
Serial number _________________________________________
Date of delivery _______________________________________
In case your product fails or have questions, please contact your nearest dealer. If you are in Mexico, please give a call to our Call Center.
HOW TO USE
TROUBLESHOOTING
SPECIFICATIONS
CAMERA
Input: 12V - - -
Consumption: 2W
Angle of vision: 53°
Minimum illumination: 0.1 lux at 30 cm
CONSUMPTION
Nominal consumption: 250 Wh/day
Stand-by power consumption: 6.57 kWh/year
Product: B&W doorphone with camera and SD card slot
Part number: CCTV-045
Brand: Steren
WARRANTY
CONDITIONS
THIS WARRANTY IS VOID IN THE NEXT CASES:
RETAILER INFORMATION
01 800 500 9000
MIC
CALL
Publicidad
