Hella 8 PW 185 103-331 Manual De Instrucciones página 11

Function test of built-in electrical components by applying a positive (+) voltage . (Fig. 5)
Use the test probe to create a contact with the positive connection of the component. The LED lights up green.
Press the rocker switch forward (+). The component is triggered and the LED lights up red.
When the LED goes out or the safety switch is triggered, the system is overloaded.
This may have several causes:
• The contact is a direct ground contact.
• The component is short-circuited.
• The component is a peak load component.
If the safety switch was triggered, reset it by pushing the reset button.
Function test of built-in electrical components by applying a negative (-) voltage . (Fig. 6)
Use the test probe to create a contact with the negative connection of the component. The LED lights up red.
Press the rocker switch backward (-). The component is triggered and the LED lights up green.
11
When the LED goes out or the safety switch is triggered, the system is overloaded.
This may have several causes:
• The contact is a positive voltage contact.
• The component is short-circuited.
• The component is a peak load component.
If the safety switch was triggered, reset it by pushing the reset button.