ASROCK P67 Transformer Manual De Instrucciones página 19

2.6 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
Primary IDE connector (Blue)
(39-pin IDE1, see p.2 No. 7)
connect the blue end
to the motherboard
80-conductor ATA 66/100/133 cable
Note: Please refer to the instruction of your IDE device vendor for the details.
Serial ATAII Connectors
(SATAII_2: see p.2, No. 13)
(SATAII_3: see p.2, No. 12)
(SATAII_4: see p.2, No. 15)
(SATAII_5: see p.2, No. 14)
(SATAII_6: see p.2, No. 8)
Serial ATA3 Connectors
(SATAIII_0: see p.2, No. 11)
(SATAIII_1: see p.2, No. 10)
Serial ATA (SATA)
Data Cable
(Optional)
ASRock P67 Transformer Motherboard
connect the black end
to the IDE devices
These fi ve Serial ATAII (SATAII)
connectors support SATA data
cables for internal storage
devices. The current SATAII
interface allows up to 3.0 Gb/s
data transfer rate.
These two Serial ATA3 (SATA3)
connectors support SATA data
cables for internal storage
devices. The current SATA3
interface allows up to 6.0 Gb/s
data transfer rate.
Either end of the SATA data
cable can be connected to the
SATA / SATAII / SATA3 hard
disk or the SATAII / SATA3
connector on this motherboard.
19