Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Product Safety Information
Intended Use:
These Air Die Grinders are designed for grinding, porting, polishing, de-burring, and breaking
sharp edges.
●
Failure to observe the following warnings, and to avoid these potentially hazardous
situations, could result in death or serious injury.
●
Always turn off the air supply, bleed the air pressure and disconnect the air supply hose
when not in use, before installing, removing or adjusting any accessory on this tool, or
before performing any maintenance on this tool or any accessory.
●
Do not attempt to disassemble the internal Speed Controller. It is available only as a
unit.
●
Before installing a new Arbor Housing Assembly, always select the correct Nameplate
Kit and secure it to the Arbor Housing with the Nameplate Screws.
For Additional information refer to Air Die Grinder Product Safety Information Manual
Form 04580288.
Manuals can be downloaded from ingersollrandproducts.com
Product Specifications
Free Speed
Model(s)
rpm
61H120G4-EU
12000
61H150G4-EU
15000
† K
= 3dB measurement uncertainty
pA
‡ K
= 3dB measurement uncertainty
wA
* K = Vibration measurement uncertainty
Sound and vibration values were measured in compliance with internationally recognized
test standards. The exposure to the user in a specific tool application may vary from these
results. Therefore, on site measurements should be used to determine the hazard level in
that specific application.
16576118_ed3
WARNING
Sound Level dB(A)
(ISO15744)
Collet Size
† Pressure
(L
)
p
1/4"
83.6
1/4"
86.8
WARNING
Vibration (m/s²)
(ISO28927)
‡ Power (L
)
Level
w
94.6
<2.5
97.8
<2.5
EN
*K
EN-1
Publicidad
Tabla de contenido
