Assembly Visiano 20-2 P Tx; Load Data; Assembly; Operation - Derungs D med VISIANO 20-2 C T1 Instrucciones De Montaje Y Funcionamiento

ENG

Insert the light and the adapter 1 into the ceiling tube 2

Insert securing element with threated pin 3 and screw in
to the stop

Loosen by one quarter-turn to ensure the operation of
the turnover axis

4. ASSEMBLY VISIANO 20-2 P TX

4.1

Load data

Bending moment M
B
Vertical weight F
G
4.2

Assembly


The lights are equipped with an adapter pin. The light
must be positioned in one of the accessories described
in chapter 9.
5.

OPERATION

CAUTION

This product emits potentially hazardous optical
radiation. Do not stare directly into the light cone. Eye
irritation may occur.

The radiation emitted by this product complies with the
exposure limits for reducing the risk of photobiological
hazards based on IEC 62471: RG 1 (low risk).
DANGER
Death hazard from electric shock.
►
Do not plug in any damaged power cables.
►
If the power cable shows damage, immediately replace
it with a new one.
►
The connection voltage and frequency must match
the data on the type plate.
►
Only connect to power grid with protective ground
conductor (PE)
20
VISIANO 10-1 C T1 / VISIANO 10-2 C T1

Insert power cable

Connect the cable to the mains

Perform a function test before every use:
All LED's in the light cone must illuminate.

25Nm

Switch the LED module on/off
20N

Set the desired colour temperature according to the
following table:
COLOUR
blue
orange

Set the desired Illuminance in 25% dimmer steps
COL. TEMP. RECOMMENDATION
cold white Ideal for identifying
individual vessels for
wound follow-up
treatment and small
procedures
warm white Ideal for various types of
skin examinations