Installing The Hdd; Completing Installation - Ezviz X3 Manual Del Usuario

3
Installing the HDD Rubber Case
Pick an appropriate rubber case according to the HDD thick,
and cover the rubber case on the two sides of the HDD, as
shown in the figure below.
If the HDD is 9mm thick, the TOP mark of the rubber case
should be facing upward when installing .
4

Installing the HDD

Connect the HDD cable to the HDD and place the HDD in the
designated position, as shown in the figure below.
5

Completing Installation

Replace the cover and fasten the 4 screws in the step 1 and
complete the installation.
TOP
TOP
5