Emptying The Tank - COLUMBIA VAC OPC 120 Manual Del Usuario

When the lock is active, you cannot change the appliance settings or turn it off.
To deactivate the lock, press and hold the dimmed "LOCK" button
"TIMER" button
and off.
- Delayed start - this function allows you to set the time after which the appliance will
automatically turn on.
The function can only be activated when the appliance is turned off but connected to the
power supply.
The delayed start can be set in the range of 1 to 24 hours by pressing the "TIMER" button
until the desired value appears on the display. You can only set full hours.
Setting the "00" value means cancelling the settings.
Function activation is indicated by an indicator light
After turning on the appliance with the button
- Automatic turn off - this function allows you to set the time after which the appliance will
automatically turn off.
The function can only be activated when the appliance is turned on (operated).
The automatic turn off can be set in the range of 1 to 24 hours by pressing the "TIMER"
button until the desired value appears on the display. You can only set full hours.
Setting the "00" value means cancelling the settings.
Function activation is indicated by the
After turning on the appliance with the button

EMPTYING THE TANK

ATTENTION
Water collected in the dehumidifier tank is not suitable for drinking and must not be
allowed to come into contact with food.
Do not put the floater out of water (Fig. 7); otherwise the device will not stop working
when the water tank fills up. Then, water will overflow, which may cause damage to
the floor.
- Pull the tank gently at the back of the device; the tank will slide out (fig.4).
- Pour the water out of the tank.
- If the water tank is dirty, clean it with water. Do not use any acrid cleaning agents. Do
not use chemical solvent (such as benzene, alcohol, gasoline). The surface may be
damaged or even the whole case may be deformed. Do not sprinkle water
- Place the tank in the right position in the device. Otherwise, the full tank indicator will
still light up red and the device will not be able to work.
- intended for automatically turning the appliance on (delayed start)
indicator light.
for a few seconds.
and the numbers on the display.
the time setting will be deleted.
the time setting will be deleted.
27