Parts List - Rampage 26410030 Instrucciones De Instalación

Parts List:

Driver/left side 3" Nerfbar
1
Passenger/right side 3" Nerfbar
1
1 Driver/left side Front Mounting Bracket
1 Passenger/right side Front Mounting Bracket
1 Driver/right side Rear Mounting Bracket
1 Passenger/right side Rear Mounting Bracket
1 Driver/left side Front Support Bracket
1 Passenger/right side Front Support Bracket
1 Driver/left side Rear Support Bracket
1 Passenger/right side Rear Support Bracket
Passenger/right side
Front Support Bracket
Passenger side
3" Sidebar
PROCEDURE:
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY BEFORE STARTING INSTALLATION. FACTORY INSTALLED OR AFTERMARKET
"ROCK RAILS," SIDE STEPS OR RUNNING BOARDS MUST BE REMOVED.
1. Start installation toward the front of the passenger side of the vehicle and find the front
threaded insert located in between the first pair of holes along the pinch weld, (Figure 1).
2. Select the Passenger side Front Mounting Bracket, (Figure 2). IMPORTANT: Use the
illustration above to properly identify the Mounting Bracket. Attach the Bracket to the threaded
insert using (1) 8mm Hex Bolt, (1) 8mm Lock Washer and (1) 8mm Flat Washer, (Figure 2).
Do not tighten hardware at this time.
16
Passenger/right side
Rear Support Bracket
Passenger/right
side Rear Bracket
Driver/left Side
Front Bracket
Passenger/right
side Front Bracket
Bracket mounting location on
Sidebar (arrow)
Page 1 of 4
4 10-1.5mm x 30mm Hex Bolts
8 10mm x 24mm x 2mm Flat Washers
4 10-1.5mm Nylon Lock Nuts
8 8-1.25mm Combo Bolts
4 8-1.25mm x 35mm Hex Bolts
4 8mm x 28mm x 3mm Flat Washers
4 8mm Lock Washers
8 6-1.0mm x 25mm Hex Bolts
6mm x 22mm x 2mm Flat Washers
8 6-1.0mm Nylon Lock Nuts
Driver/left side Rear
Support Bracket
Driver/left side
Rear Bracket
3" NERFBAR
2018-19 WRANGLER JL 2DR
Driver/left side Front
Support Bracket
Front
07/25/18 (RA)