Installation And Operating Instructions; Symbols Used In This Document; System Sizing; Mechanical Installation - Grundfos CM PM1 Guía Rápida

English (GB) Installation and operating instructions
Original supplement to Quick Guide.
CONTENTS
1.

Symbols used in this document

2.

System sizing

3.

Mechanical installation

4. Electrical connection
5. Start-up
6. Alarms
6.1 Anti-cycling
7. Fault finding chart
8. Disposal
Warning
Prior to installation, study the Quick
Guide carefully. Installation and
operation must comply with local
regulations and accepted codes of
good practice.
Warning
The use of this product requires
experience with and knowledge of the
product.
Persons with reduced physical,
sensory or mental capabilities must
not use this product, unless they are
under supervision or have been
instructed in the use of the product by
a person responsible for their safety.
Children must not use or play with this
product.
8
1. Symbols used in this document
Warning
If these safety instructions are not
Page
observed, it may result in personal
8
injury.
8
If these safety instructions are not
8
Caution
observed, it may result in malfunction
9
or damage to the equipment.
9
Notes or instructions that make the job
9 Note
easier and ensure safe operation.
9
10
2. System sizing
11
Warning
The system in which the CM Booster is
incorporated must be designed for the
maximum pump pressure.
The default setting will cause the pump
Caution
not to stop until it reaches its maximum
pressure.
3. Mechanical installation
Warning
Before starting any work on the
CM Booster, make sure that the power
supply has been switched off and that
it cannot be accidentally switched on.