assembly (continued)
14
Attaching the anti-tip device to the
mantel
□ Attach one of the mounting brackets (KK) securely to the back
edge of the mantel. Use the small screws (MM) to secure it to
the mantel.
15
Attaching the anti-tip device
to the wall
□ Determine the location of the fireplace and mark the location on
the wall for the other mounting bracket (KK) screw holes. Using a
drill or screwdriver, make the holes in the wall where marked.
□ If you are attaching to drywall or plaster, insert a wall anchor (OO)
into each hole in the wall.
□ Position the mounting bracket (KK) over the holes in the wall
and use the large screws (LL) to securely attach the mounting
bracket (KK) to the wall.
16
Securing the anti-tip device
WarninG: This product is only a deterrent. It is not a substitute for
proper adult supervision.
□ Place the mantel so the mounting bracket (KK) on the back edge
is in alignment with the mounting bracket (KK) on the wall.
□ Place an end of the nylon strap (NN) down through each
mounting bracket (KK). Bring both ends together and slide the
end of the nylon strap (NN) through the slot in the other end until
snug. Pull down on the end until it snap-locks into the slot.
□ Check to ensure the nylon strap (NN) is securely laced and
locked to the mounting brackets (KK).
OO
LL
WALL
MM
MANTEL
13
Please contact 1-877-527-0313 for further assistance.
MM
KK
LL
NN
HAMPTONBAY.COM
KK
KK