Pentair 3200 NXT Manual De Uso página 34

3200 NXT EN _P19-35
As soon as programming mode is entered, all parameters can be displayed or set to suit your
needs. Depending on the current programming, some functions will not be displayed or will not
be changeable.
Programmation access
The valve is in service
- Press and hold the buttons
- Use the buttons
- Use the button
In order to store the new settings in the programming mode, you have to go through all the
E parameters.
N
To exit the programming mode without storing any changes, press and release the button D.
G
Note : If none of the buttons are pushed for 5 minutes in the Programming mode, or if there is a
power failure, the electronics returns to Service mode and any changes made are not stored.
L
I
Resets
There are two methods to reset. Once you have completed this operation, it is necessary to
S
check all steps of programming.
H
- Partial reset: all the parameters will be set to default values, except flow meter totalizer volume.
- Master reset: ALL the parameters will be set to default values. Disconnect the power supply
5.1
Language choice
Ce paramètre permet de choisir la langue d'affichage des paramètres :
- English
- French
- German
- Italian
- Spanish
5.2
System type
This parameter selects the system in which the valve operates.
Example: 4 single, one valve only
S Y S T E M
S I M P L E X
5.3
Valve position in the system
Only visible in multiple valve systems 5, 6, 7 and 9
This parameter shows the valve position in the system. The number #1 is the lead valve (master)
and contains the programmed parameters that will be used by the other electronics in the
system in order to control the regeneration and service or standby positions.
Example: Valve #1 (master)
V A L V E
32
19/01/10 14:10 Page 32
5 - PROGRAMMING
and to adjust the values.
to move the cursor to the next digit to be adjusted.
Press and hold the buttons
from the valve, press and hold the button
S E L E C T
T Y P E
A D R E S S :
and for 5 seconds.
for 25 seconds until the display shows time of day 12:00.
and
while reconnecting the power supply.
L A N G U A G E :
F R A N C A I S
: 4 5 # 1
V O L U M E
V A L V E
# 1
System multiple valves
S R V 1 0 : 1 5 H R
2 5 0 0 0 L
Valve #2
A D R E S S :
# 2
3200 NXT