Delta CP4301372 Guia De Inicio Rapido

PACKAGE CONTENTS / CONTENU DE L'EMBALLAGE
/ CONTENIDO DEL PAQUETE
Mounting Flange
Bride de montage
Brida de montaje Flange Cover
(if applicable)
Couvre-bride
A
(si applicable)
Cubierta de la brida
(si corresponde)
Grab Bar
Barre d'appui
Barra de agarre
WALL ANCHORS (SOLD SEPARATELY)
ANCRAGE MURAL (VENDUS SÉPARÉMENT)
ANCLAJE DE PARED (SE VENDEN POR SEPARADO)
Rotating Flange Arm
Bras de bride tournant
Brazo de brida giratoria
C
Threaded Insert
Insert fileté
x1
Inserto roscado
1/4-20 3"
Machine Screw
Vis à métaux 1/4-20
D de 3"
Tornillo para metal
1/4–20 de 3 pulg.
DF549
REQUIRED TOOLS / OUTILS REQUIS /
HERRAMIENTAS NECESARIAS
Safety Glasses
Lunettes de sécurité
Gafas de seguridad 3/8" Power Drill
Perceuse électrique de 3/8"
Taladro eléctrico de 3/8 pulg.
Pencil
Crayon
1/4" Carbide Drill Bit
Lápiz
(for tile with studs)
Foret de carbure de 1/4"
(pour le carrelage avec montants)
Broca de carburo de 1/4 pulg.
(para el azulejo con montantes)
Level
Niveau
Nivel
Silicone
Silicone
1/2" Drill Bit or Hole Saw
Silicón
(for wall anchor)
Foret de 1/2" ou scie cylindrique
(pour ancrage mural)
Broca de 1/2 pulg.
(para anclaje para pared)
CP4301372
Grab Bar / Barre d'appui / Barra de agarre
B
x6
#10 2.5" Wood Screw
Vis à bois #10 de 2,5"
Tornillo para madera
#10 de 2.5 pulg.
Mounting Plate
Plaque de montage
Placa de montaje
Brace Bar
Barre de renfort
Barra de soporte
Tape
Ruban adhésif
Cinta adhesiva
x3
#10-24 1/4"
Machine Screw
Vis à métaux #10-24
de 1/4"
Tornillo para metal
#10–24 de 1/4 pulg.
7/64" Drill Bit
(for drywall with studs)
Foret de 7/64 po
(pour le carrelage avec montants)
Broca de 7/64 pulg.
(para el azulejo con montantes)
#2 Phillips Screwdriver
Tournevis cruciforme #2
Destornillador Phillips #2
Stud Finder
Localisateur de montants
Detector de vigas
1/2" Carbide Drill Bit
(for tile with wall anchor)
Foret de carbure de 1/2"
(Pour le carrelage avec ancrage mural)
Broca de carburo de 1/2 pulg.
(para azulejo con anclaje para pared)
©2019 Liberty Hardware Manufacturing Corporation, A MASCO COMPANY
IMPORTANT SAFETY INFORMATION
INFORMATIONS IMPORTANTS EN MATIÈRE DE SÉCURITÉ À LA PAGE 3
IMPORTANTE INFORMACIÓN DE SEGURIDAD EN LA PÁGINA 3
Read all instructions and warnings prior to beginning installation of this Grab
Bar. Save this instruction booklet for future reference.
WARNING To reduce the likelihood of injury, thoroughly read and
understand all safety information and instructions provided in this instruction
booklet. If you are unable to understand any of the safety information and/or
installation instructions, contact a professional for assistance before
attempting to install.
SAFETY INFORMATION FOR INSTALLATION
WARNING ELECTRICAL SHOCK HAZARD! CUTTING OR DRILLING
INTO ELECTRICAL CORDS OR CABLES CAN CAUSE DEATH, SERIOUS
PERSONAL INJURY AND FIRE! ALWAYS make certain area behind mounting
surface is free of electrical wires and cables before drilling or installing
fasteners. Proper installation is extremely important. If in doubt, installation
should be done by a qualified professional.
WARNING To avoid injury to eyes, wear safety glasses during
installation of Grab Bar.
WARNING To help reduce the likelihood of serious injury, read and comply
with all safety information and instructions. Grab Bar may not provide the
designed amount of support unless these installation instructions are strictly
followed.
• Grab Bar was designed and tested for interior bathroom use. Grab Bars add
security for bath and commode areas if attached as instructed. Location, size,
and angle of bars should be determined by a qualified professional to provide
optimum safety and function. This Grab Bar can be installed in the bathing
area. For placement recommendations, please visit our website at
www.LibertyHardware.com.
MUST be secured to a wall stud. If a wall anchor must be used,
• Both ends
the safest practice is to have one side of the grab bar attached to a wall stud.
Only use DF549 (pictured to the left) or other wall anchor designed for Grab
Bar installation.
• At least two (2) of the three (3) screws on each end of the Grab Bar
through the wallboard or tile and be tightly secured into the wall stud or wood
blocking, unless a wall anchor is used.
SAFETY INFORMATION FOR USE OF GRAB BAR
WARNING This Grab Bar can provide support and increased stability for
an individual weighing up to 500 pounds. Grab Bars are
support the total weight of an individual. To reduce likelihood of falling or
serious injury due to failure of Grab Bar:
• Use Grab Bar for assistance ONLY.
• DO NOT stand, sit, or step on Grab Bar.
• DO NOT use Grab Bar as a step or platform to reach area above the bar.
WARNING Falls can cause a serious injury. To reduce that risk:
• Grasp the Grab Bar when exiting or entering the bathtub or when sitting down
or rising from the commode.
• Use caution on wet tub or floor surfaces. Wet tub or floor surfaces increase
the risk of a fall.
• Supervise and/or assist users with limited physical capabilities in bath and
commode areas, even when using Grab Bars.
• DO NOT use Grab Bar if any looseness is noted. After ANY adjustments,
BEFORE use, make sure that all attaching hardware
repair or service and
is securely tightened.
CARE AND MAINTENANCE
• Use of mild soap and water ONLY is recommended for cleaning.
• Periodically inspect the assist bar for damage or looseness.
BEFORE YOU BEGIN / AVANT DE COMMENCER /
ANTES DE EMPEZAR
Remove the Grab Bar and parts from package. Read all safety information
on page one and review instruction steps. If concealed screw Grab Bar is
used, move cover plates away from mounting plates.
Retirez la Barre d'appui et les pièces de l'emballage. Lisez toutes les
consignes de sécurité à la page quatre et examinez les instructions par
étapes. Si une Barre d'appui à vis dissimulées est utilisée, déplacez les
plaques de recouvrement des plaques de montage.
Saque la Barra de agarre y las piezas del paquete. Lea toda la información
de seguridad en la página cuatro y revise los pasos de las instrucciones.
Si utiliza un tornillo oculto para la barra de agarre, mueva las placas de la
cubierta a un lado de las placas de montaje.
MUST go
NOT designed to
REV 03/18/2019