Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
Equipment Required:
Fastener Kit: 65700F
Wrenches: 15mm, 16mm, 17mm
Drill Bits: None
Fasteners typical both
mounting locations
1
Qty. (2)
Hex Bolt M10 x 1.50 x 70mm CL8.8
2
Qty. (2)
Flat Washer M10
3
Qty. (2)
Lock Washer M10
1.
Remove and return factory hitch and fasteners to vehicle owner.
2.
Raise hitch into position and install fasteners as shown, installing hex bolt and flat washer thru round hole in hitch top plate,
vehicle frame and hitch lower plate. Install lock washer and hex nut as shown. Repeat for both mounting locations.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2007 Cequent Towing Products
Installation Instructions
Honda ATV (650 and 680)
With Independent Rear Suspension
Tighten all M10 x 1.50 CL8.8 fasteners with torque wrench to 38 Lb.-Ft. (51 N*M)
Do Not Exceed Lower of Towing Vehicle
Manufacturer's Rating or
Hitch type
Weight Distribution
Weight Carrying
Ball Mount
Wiring Access Location: N/A
4
Qty. (2)
Hex Nut M10 x 1.50
Sheet 1 of 3
65700N
Part Numbers:
65700
Max Gross
Max Tongue
Trailer WT (LB)
WT (LB)
Not to be used with Spring bars
1000 (454 Kg)
100 (45 Kg)
1234
Vehicle Frame
6-19-07
Form: F205 Rev A 5-6-05
Rev. A
Publicidad
Manuales relacionados para Cequent Towing Products 65700
Resumen de contenidos para Cequent Towing Products 65700
- Página 1 This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684. Sheet 1 of 3 65700N 6-19-07 Rev. A 2007 Cequent Towing Products Form: F205 Rev A 5-6-05...
- Página 2 Ce produit est conforme aux normes V-5 et SAE J684 de la V.E.S.C. (État de New York) concernant les spécifications en matière de sécurité des systèmes d’attelage. Feuile 2 de 3 65700N 6-19-07 Rev. A 2007 Cequent Towing Products Form: F205 Rev A 5-6-05...
- Página 3 Este producto cumple con las especificaciones y requisitos de seguridad para conectar dispositivos y sistemas de remolque del estado de Nueva York, V.E.S.C. Regulación V-5 y SAE J684. Hoja 3 de 3 65700N 6-19-07 Rev. A 2007 Cequent Towing Products Form: F205 Rev A 5-6-05...