Important; Installing Axkid Bigkid 2 Car Seat In The Vehicle - Axkid Bigkid 2 Manual De Instrucciones

Allowed and disallowed positioning of Axkid Bigkid 2
The Axkid Bigkid 2 can be used on any forward-facing passenger seat which has a 3-point seat belt, approved to UN/
ECE Regulation No. 16 or other equivalent standard. The Axkid Bigkid 2 cannot be used with a 2-point lap belt.
Front passenger seat (no active airbag)
Front passenger seat (active airbag)
Forward-facing seat with 3-point safety belt
Seat with 2-point safety belt
Side-facing seats
Rear-facing seats
IMPORTANT: The child should be a minimum of 140 cm in height to sit in front of an active airbag unless there are other
recommendations from the car manufacturer. If you still wish to install Axkid Bigkid 2 in such seating position the airbag
must be switched off according to the vehicle manufacturers instructions. It is important to always check if the vehicle' s
indicator light shows that the airbag is turned off.
IMPORTANT: Never use on rearward or side facing vehicle seats.

Installing Axkid Bigkid 2 car seat in the vehicle

1. Place the Axkid Bigkid 2 in a suitable forward-facing position equipped ISOFIX connection points. If the vehicle' s
seat back is adjustable, ensure it is in the upright position.
2. Extend the ISOFIX connectors (H) by pushing the ISOFIX adjustment handle (J) and extending the sliders
3. Insert the ISOFIX connectors (H) to the ISOFIX connection point in the car. Make sure that there is a "click" sound
and a green indication on both ISOFIX indicators (H).
4. Push the Axkid Bigkid 2 towards the vehicle seat back until there is no space between the vehicle seat back and the
Axkid Bigkid 2.
5. Attach the ASIP (M) by locating the side ASIP attachment (C) on the side of the Axkid Bigkid 2 closest to the vehicle
door. Press the ASIP button (N) and slide it into position.
i
9
YES
NO*
YES
NO
NO
NO
ii