General Information About Programming; Programming; Call For The Programming Mode; Programming Mode - Kübler CODIX 533 Manual Del Usuario

3.3 General Information about Programming

Note
When this manual instructs to
press both keys simultaneously,
press the left key slightly before
⇑ ⇑
the right key.

4. Programming

4.1 Call for the Programming Mode

To call the programming mode:
1. Press simultaneously both front side keys and
hold them pressed for at least 3 seconds.
⇑
⇑
2. The following message is displayed
3. In addition, a blinking request for confirmation is
displayed. Press the right key to switch over bet-
ween YES and No
⇑
4. If YES is displayed and both keys are pressed,
the programming mode is called for. no exits the

programming mode

⇑ ⇑
4.2 Programming Mode
1. Press the right key and select the operating
mode:
⇑
2. 3 operating modes are available
3. After selecting the operating mode, press both
keys. Programming can start now.
⇑ ⇑
The three operating modes can be programmed
independently of each other.

4.2.1 The SEtP Operating Mode

1. The following parameters can be programmed
for the SEtP mode:
⇑ ⇑ ⇑
to
for mA 24.00
to
for mA 24.00
EN - Page 5