Assembly - Costco RC3218 Instrucciones De Ensamble Y Cuidado

UNPACKING
Remove the pack from the top of the pallet, remove the grill from the pallet carefully. When lift the grill, keep it in
balance, do not let the bottom panel hit the pallet. Otherwise the bottom panel will be damaged.
Open grill lid and side burner cover, cut the zip tie which hold the grill part.
WARNING: Assemble the grill on a flat level surface. Do not attempt assembly if any part is missing or
damaged.
Call Grill Service Center For Help And Parts
If you have questions or need assistance during assembly, please call 888 80 GRILL (888 804 7455). You will be
speaking to a representative of the grill manufacturer.
1. Open the cabinet door, detach the left LP cylinder stopper by removing the screws which hold the LP cylinder
stopper in the bottom panel and the rear panel. Take out the side shelf assembly box from the cabinet. Then
assemble the LP cylinder stopper back using the screws you removed.
Side shelf assembly
box
2. Open the side shelf assembly box and take out the side shelves.
Loosen the four screws attached to the left panel of the burner box 3 to 4 turns as shown. Hang the left side shelf
by the slotted holes in its side onto the four loosened screws. Tighten the four previously loosened screws.
LP cylinder stopper
Loosen
Loosen