Installation Steps - LUND LUNDRB06 Instrucciones De Instalación

Installation Steps

Insert Bolts through bracket and thread into
3
Insert U-Clips into shown locations for
center bracket installation.
5
Insert Bolts through bracket and thread into
7
Insert four (4) Square head bolts into the
track. Two (2) in each outside channel.
Repeat for all brackets.
9
NOTE: Actual application may vary slightly from drawings.
U-Clips.
U-Clips.
4
Repeat in two locations at Driver side and
6
8
Line up square head bolts through bracket
holes. Install washers and nuts on each bolt.
10
Page 2 of 3
Tighten all bolts.
Passenger side.
Tighten all bolts.
Position board as far out on the bracket and
tighten all fasteners.
Washer
Flanged
Nut