Uline H-2760 Guia De Inicio Rapido página 2

For ease of packing, the handle and side brush
assembly are packed separately. These parts must be
installed before the machine is put into operation.
The handle is mounted by means of knobs. Handle can
be fixed in two different positions as shown below.
Handle Position 1
Handle Position 2
PAGE 2 OF 15
ASSEMBLY
SIDE BRUSH ASSEMBLY
1. Mount the side broom to the brush plate on the side
arm assembly using hex head bolt and nylock nut.
2. Position the V-Belt from the side arm assembly
around the pulley attached to the backside of the
right wheel. In order to do this it will be necessary to
twist the V-Belt. The lower loop of the V-Belt should
come from the idler pulley (not from the broom
pulley).
3. Attach the side arm assembly with the support side
brush on the frame by loosening the screws fixed
onto the frame. Place the V-Belt onto the drive pulley
on the wheel, adjust the arm assembly forwards or
backwards to the desired tension. Fasten the arm
assembly by tightening the screws. Check the brush
for free rotation.
4. Check for proper rotation and operation of the side
broom. The broom should rotate counterclockwise
when the sweeper is pushed forward, if not, the
V-belt was installed incorrectly. If the belt slips, the
tension can be adjusted by loosening the 2 screws
that attach the support side brush to the frame,
move the bracket forward, then retighten the screws.
From Idler
Pulley
V-Belt
Support
Side Brush
Side Brush Assembly
Screws
Move
0421 IH-2760