Uline H-2760 Guia De Inicio Rapido página 3

1. PRESSURE ADJUSTMENT KNOB FOR SIDE BRUSH
Used for setting the side brush. The side brush should
only partially touch the floor to throw swept particles
into the machine.
The caster wheel keeps the preset working height of the
side brush.
2. PRESSURE ADJUSTMENT KNOB FOR MAIN BRUSH
Used for setting the main brush pressure. The pressure
must be set to assure perfect cleaning operation.
3. KNOBS
Used to secure the handle to the machine or to
reposition it.
4. MAIN BRUSH PRESSURE READING SCALE
Indicates the pressure at which the main brush has
been set. Setting must be performed as described
below:
• Set the main brush by turning the knob clockwise
to increase the pressure. The scale should read '5' .
• Starting with this setting, the main brush pressure
can be increased to maintain performance (as the
brush wears out).
• Turn the knob counterclockwise to reduce the main
brush pressure according to the need.
NOTE: Excess pressure will cause unnecessary
brush wear and increased load for the
operator.
The Kleen Sweep 27 operates with two brushes. The side
brush takes dirt from the side into the reach of the main
brush. The main brush maintains its direction of rotation
to throw the dirt into the hopper as the machine moves
forward.
NOTE: In case of obstacles in the sweeping
path, the Kleen Sweep 27 should be pressed
down at the handle. This will cause the two
brushes to lift off the floor and the machine
can easily pass over these obstacles.
PAGE 3 OF 15
CONTROLS
+
20
15
10
5
––
OPERATION
EMPTYING OF HOPPER
The hopper can be easily lifted by using the handle
provided. The hopper is secured to the machine frame.
The hopper must be in direct contact with the brush
compartment in order to prevent dirt leakage.
3
1
2
4
0421 IH-2760