Dual Assignment Instructions (Long Button Press) - Metra Electronics Axxess BX-CH34 Instrucciones De Instalación

Tabla de contenido

Idiomas disponibles

Steering wheel audio control extra settings

Dual assignment instructions (long button press)

The BX-CH34 has the capability to assign (2) functions to a single button,

except Volume-Up and Volume-Down. Follow the steps below to program the

button(s) to your liking.

Note: Seek-Up and Seek-Down come pre-programmed as Preset-Up and

Preset-Down for a long button press.

1) Turn on the ignition but do not start the vehicle.

2) Press and hold down the steering wheel control button that you want to assign

a long press function to for about (10) seconds, or until the L.E.D. flashes

rapidly. At this point release the button; the L.E.D. will then go solid.

3) Press and release the Volume-Up button the number of times corresponding

to the new button number selected. Refer to the Dual Assignment Legend. The

L.E.D. will flash rapidly while the Volume-Up button is being pressed, and then

go back to a solid L.E.D. once released. Go to the next step once the Volume-Up

button has been pressed the desired number of times.

Caution: If more than (10) seconds elapses between pressing the Volume-Up

button, this procedure will abort, and the L.E.D. will go out.

4) To store the long press button in memory, press the button that you assigned a

long press button to (the button held down in Step 2). The L.E.D. will now go off

indicating the new information has been stored.

Note: These steps must be repeated for each button you would like to assign

dual purpose feature to. To reset a button back to its default state, repeat Step

1, and then press the Volume-Down button. The L.E.D. will go off, and the long

press mapping for that button will be erased.

BX-CH34

Dual assignment legend

1. Not allowed

2. Not allowed

3. Seek-Up/Next

4. Seek-Down/Prev

5. Mode/Source

6. ATT/Mute

7. Preset-Up

8. Preset-Down

9. Power

10. Band

11. Play/Enter

12. PTT