Steering wheel audio control extra settings
L.E.D. feedback
The (16) Red L.E.D. flashes represent what brand radio the BX-CH34 believes it is
connected to. Each flash represents a different radio manufacturer. For example,
if you are installing a JVC radio, the BX-CH34 will flash Red (5) times, and then
stop. Following is a legend that dictates which radio manufacturer corresponds to
which flash.
BX-CH34
L.E.D. feedback legend
1st L.E.D. flash is for Eclipse (Type 1) †
2nd L.E.D. flash is for Kenwood ‡
3rd L.E.D. flash is for Clarion (Type 1) †
4th L.E.D. flash is for Sony and Dual
5th L.E.D. flash is for JVC
6th L.E.D. flash is for Pioneer and Jensen
7th L.E.D. flash is for Alpine *
8th L.E.D. flash is for Visteon
* Note: If the BX-CH34 flashes (7) times, and you do not have an Alpine radio connected to
it, that means the BX-CH34 does not detect a radio connected it. Verify that the 3.5mm jack is
connected to the correct steering wheel jack/wire in the radio.
** Note: Part number AX-SWC-PARROT is required (sold separately). Also, the Parrot radio must
be updated to rev. 2.1.4 or higher through www.parrot.com.
† Note: If you have a Clarion radio and the steering wheel controls do not work, change the radio
type to the other Clarion radio type; same for Eclipse. The following section explains how to do this.
‡ Note: If you have a Kenwood radio and the L.E.D. feedback comes back as showing as a JVC
radio, change the radio type to Kenwood. The following section explains how to do this.
7
9th L.E.D. flash is for Valor
10th L.E.D. flash is for Clarion (Type 2) †
11th L.E.D. flash is for Metra OE
12th L.E.D. flash is for Eclipse (Type 2) †
13th L.E.D. flash is for LG
14th L.E.D. flash is for Parrot **
15th L.E.D. flash is for XITE
16th L.E.D. flash is for Philips