HP Designjet T620 Serie Manual Del Usuario página 4

Table 1 Text messages (continued)
Message
[Color] printhead #[n] out of war-
ranty
[Color] printhead #[n] warranty
warning
IO error
IO warning
Paper advance calibration pending
Paper too small to print paper
advance calibration
Paper too small to scan paper
advance calibration
PDL Error: Ink system not ready
PDL Error: memory full
PDL Error: parsing error
PDL Error: print mode error
PDL Error: printing error
PDL Error: virtual memory full
Reseat [color] cartridge
Update: failed. Invalid file
Table 2 Numerical error codes
Message
01.0, 01.1, 01.2, 21, 21.1, 22.0,
22.1, 22.2, 22.3, 24, 79
52:01
61:01
62, 63, 64, 65, 67, 74.1
94, 94.1
3
Recommendation
The printhead's warranty has expired, because of the length of time it has
been in operation or because of the volume of ink used.
The printhead's warranty may be invalidated by the use of the wrong
kind of ink.
Restart the printer. If the problem persists, contact HP Support. See Using
your printer.
Try again; if the problem persists, contact HP Support. See Using your
printer.
Perform paper advance calibration. See Using your printer.
Unload paper and load larger paper.
Unload paper and load larger paper.
Clean the printheads. See Using your printer.
Restart the printer and try resending the job; if necessary, reduce the
complexity of the job.
The print job is unintelligible to the printer. Try to recreate and resend it.
Check your cable connections.
The paper type or print quality specified for the job are incorrect. Change
the loaded paper type or the print settings.
Try sending the job again.
Restart the printer and try resending the job; if necessary, reduce the
complexity of the job.
Remove and reinsert the same cartridge. See Using your printer.
Make sure you have selected the correct firmware update file. Then try the
update again.
Recommendation
Restart the printer. If the problem persists, contact HP Support. See Using
your printer.
The printer needs internal cleaning. See Using your printer.
The file format is wrong and the printer cannot process the job. See Using
your printer.
Update your printer's firmware. See Using your printer.
Restart color calibration. See Using your printer.