The threaded rods of the wind safety device are only tightened by hand. Ensure that the helical springs
remain released while the rods are installed.
Otherwise extreme rainfall may lead to interior leaks which cause discoloration and damage to the wood.
The manufacturer will accept no liability for such damage, there will be no replacement within the scope of
the guarantee nor is it covered by the manufacturer's warranty. We therefore refer you again to our
guarantee conditions at this point.
Wood protection
The product is made from natural timber, for which regular and adequate wood preservation measures are
obligatory. Please contact a wood preservation expert for information on professional preservation
measures.
Wood preservation is to be carried out by the customer at his own risk. No guarantee can be given in the
event of wood preservation not carried out in accordance with the instructions. Please also note the
provisions relating to this in our guarantee. We wish you much pleasure with your wood product.
Guarantee conditions
weka Holzbau GmbH provides you with a 5-year guarantee for design and processing quality. Within the
guarantee time, faulty parts will be replaced free of charge. Costs arising as a result of the exchange are not
included in the guarantee claim.
Guarantee claims may only be made in conjunction with the original packing list and proof of purchase.
Excluded from the guarantee are defects caused by:
improper subsoil and foundations
-
assembly not carried out in accordance with these instructions
-
snow load in excess of 0,75 kN/m²
-
your own alterations to the product
-
defective care in the maintenance of the current wood quality
-
prevailing winds in excess of force 7 (stiff wind)
-
Natural catastrophes or other violent occurrences.
-
Fluctuations in colour, crack formation, warping or similar changes which are completely normal
outdoors are no grounds for making a claim.
Further claims and consequential damage do not fall under the guarantee regulations. Our General Terms
and Conditions apply.
You should have the following tools to hand before beginning assembly.
Spring tape measure/
measuring tape
Mitre saw/
hand disk saw
Abbreviations: - RW = Rear wall
- WS= Wall strength
Symbols:
Techn. Änderungen vorbehalten!
Inland, consequences such as the movement of whole trees and any noticeable
impedance when walking in the open air are to be observed. No defects due to these
conditions will give rise to a guarantee.
Electric
Drill
screwdriver
Universal cutter
- mm = Millimetre
- Wall strength 21mm
Alle Maßangaben sind ca. Maße
Hammer
Pencil
Cord
Spirit level
5
Burring
Rubber
iron
mallet
Spanner
Copyright HRB 3662