Style selections 2165WWMV Manual De Instrucciones página 5

ASSEMBLY INSTRUCTIONS
2. NOTE: THIS ASSEMBLY IS SHOWN FOR 97 IN.
OPENING HEIGHT. The following assembly
should be modified based on your opening height,
SEE CHART ON PAGE 4.
Place a wedge (DD) (tapered or rounded end up)
on a long-tapered tube (C) approximately half
way down and slide a shelf (F) down the tube
and fit over the wedge (DD).
Place another wedge (DD) (tapered or rounded
end up) on a long-tapered tube (C) and slide
another shelf (F) down the tube and fit over the
wedge (DD).
Repeat this step for the medium tapered
tube (D) and the other shelves (F). NOTE: Shelves
can be adjusted by moving the wedges (DD) up
or down.
Hardware Used
Wedge
DD
3. Decide on which shelf (F) you would like to have the
washcloth bar (H) on.
Look under the shelf and slide the washcloth bar (H)
up into the groove of the left or right side of the
shelf (F) and push into place.
NOTE: The button on the back of the washcloth bar
MUST snap into the hole in the back of the shelf.
IS2265
2
F
x 4
3
F
5
C
DD
hole
in shelf
H
DD