Style selections 2165WWMV Manual De Instrucciones página 8

ASSEMBLY INSTRUCTIONS
8. Place the small end cap (BB) onto the 3/4 in. tube (A).
Insert the transition ring (EE) into the straight tube (B).
Slide the 3/4 in. tube (A) through the transition
ring (EE) and into the straight tube (B), as shown.
Place the tape strips (GG) around the seams of
the tubes.
NOTE: After inserting the 3/4 in. tube (A) into
the straight tube (B) ensure that the transition
ring (EE) fits snuggly over the straight tube (B).
Hardware Used
BB
Small End Cap
EE
Transition Ring
Tape Strip
GG
9. NOTE: Make sure you are installing in a clean,
dry and safe environment.
Compress the TOP of the unit against the ceiling in
the desired location, fig 1.
Now, move the BOTTOM end into place so that the
unit is in a vertical position, fig 2.
IS2265
8
EE
x 1
x 1
x 1
9
8
BB
A
A
B
B
B
GG
C
fig. 1
fig. 2