Safety Precautions - Drive Medical R800RD Guia De Inicio Rapido

Rollator
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

assembly instructions
Do not attempt to adjust or operate Rollator without
carefully reading all instructions in this manual.
1. First remove all contents from carton.
2. Open frame and slide padded backrest into frame
brackets making sure snap bottoms protrude
through holes.
3. Remove tightening knob from packaging and insert
handle tube into frame at desired height lining up
holes appropriately. Slide bolts through holes from
the inside and screw on tightening knob until secure.
R800RD Shown
Orthodic
Hand Grips
Comfortable
Padded Seat
Hanging Bag
for Functionality
& Storage
Weight Capacity 300 lbs (136 KG)
Loop Locks
Safest System
Available
Backrest
Height
Adjustable
Folding
Hinge for
Portability

safety precautions

1. Please make sure the Rollator is fully opened, seat
is down and the folding bar under seat is locked in the
down position.
2. Be sure that both knobs are fully tightened and are at
equal heights. Test Rollator for stability before
applying full weight to hand grips.
3. Test the loop locks before operating the Rollator.
When wheels are locked (see illustrations for locking
and releasing locks below), lock bar on rear wheels
should prevent wheels from rolling. If the wheels
roll while brakes are locked, please take unit back
to dealer for adjustment. When locks are released,
the wheels should roll freely.
4. Always lock loop locks before sitting and do not use
seat when unit is on an incline or uneven ground.
5. Replace tires when significantly worn or damaged.
Important Safety Notice
Do not have anyone push you while you are seated on
the Rollator. This is a walking aid only and is not to be
used as a transportation device.
loop lock operation
Always engage and disengage wheel locks on both sides
simultaneously.
1. To Slow Down or Come to a Temporary Stop—Pull
up slowly on the loop locks with four fingers until unit
slows down or comes to a temporary stop.
2. To Temporarily Lock Wheels in Position—Press down
on both loop locks with palms until you hear a "click"
that will tell you wheels are locked.
3. To Release Wheel Locks—Pull up on both loop locks
with palms of hand to original position.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

R800bl

Tabla de contenido