Sauder Costa 546411 Instrucciones De Montaje página 12

Step 8
Diagram 1. Measure 1-1/2" from one end of the INTERLOCK TRACK (22G). Position the INTERLOCK TRACK as shown.
å
SAFETY STOP / TRACK ATTACHMENT:
å
Diagram 2. Tilt the fi rst edge of the INTERLOCK TRACK (22G) into the SAFETY STOPS (29G).
å
Diagram 3. Rotate the INTERLOCK TRACK and apply force to snap the second edge into the SAFETY STOP.
å
Diagram 4. Repeat the SAFETY STOP / TRACK ATTACHMENT for the next SAFETY STOP while holding the previously
å
completed SAFETY STOP in its location hole. Repeat these steps until all STOPS have been attached. Visually check
that all INTERLOCK TRACK edges have been snapped into the SAFETY STOPS as shown in diagram 3.
Diagram 5. Remove the INTERLOCK TRACK assembly from Diagram 4 and fl ip it over before inserting the INTERLOCK
å
TRACK (22G) with SAFETY STOPS (29G) into the groove in the RIGHT END (A).
Be sure the
interlock track
snaps into each
SAFETY STOP.
5.
Page 12
The interlock system is a safety feature
that prevents more than one drawer
from opening at the same time. Do not
use excessive force to open the drawers.
A
22G
A
22G
29G
4.
22G
2.
1.
Tape Measure
22G
3.
29G