Sauder Costa 546411 Instrucciones De Montaje página 13

Step 9
Separate the EXTENSION SLIDES (45MC) from the EXTENSION RAILS (45MA) as shown in the enlarged diagram
å
below. Be prepared, the parts are greasy.
Fasten the EXTENSION RAILS (45MA) to the ENDS (A and B). Use eight GOLD 5/16" FLAT HEAD SCREWS (3S)
å
through holes #1 and #3.
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
å
cartridge of the EXTENSION RAIL out to fi nd the other hole that lines up with the hole in the END. Turn a SCREW
into this hole.
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
å
45MC
Push the black lever in and pull the SLIDE from the RAIL.
1
Open end
4
3
2
B
2
1
45MA
GOLD 5/16" FLAT HEAD SCREW
(8 used in this step)
2
3
4
A
4
3
After fastening the EXTENSION RAILS to the RIGHT END (A),
the SAFETY STOPS should touch the top edge of the RAILS.
If the gap is larger than 1/16", the drawers could lock up and
not open. If this happens, open two drawers at the same time
to override the interlock system. Remove the drawers to
re-adjust the INTERLOCK TRACK assembly.
3S
1
1
2
3
4
Open end
SAFETY STOP
Page 13