Alice's Garden OMBREC Manual De Instrucciones página 38

EN
STEP 3A: INSTALLING ON A SOLID WALL
1. Drill the previously marked holes with a drill and 16mm bit. The holes must be at least 11cm deep.
2. Insert the expansion anchors with a hammer (if necessary)
propriate Allen key or an adjustable spanner. This action embeds the anchor into the wall.
3. Once the anchors are fixed in the wall, you can remove the screws.
4. Position the awning bracket
5. Repeat this process for the other brackets, once you have checked the brackets are level.
1
≥11cm
≥9cm
Drilled holes Ø16mm
4
3
3
When they are fully inserted, the brackets must be held firm in the wall.
38
≥9cm
3
2
and screw the screws back in, without forgetting the washers.
2
3
Anchors Ø16mm
5
2
If they move, tighten them further.
3
and tighten the screw using the ap-
3
2
2
2
06/11/2019