C-Pen TS 1 Guia De Inicio Rapido página 5

How Do I Use the C-Pen?
The C-Pen Core software will display the text you scan. The
scanned text will be inserted at the cursor position. This means
that you can scan text into any standard program.
This is an example on how to scan text into MS Word.
– First check that the C-Pen Core status windows reports
thatyour C-Pen is connected.
– Start MS Word.
– Place the cursor where you want the text to appear. Do
NOTclick anywhere else as this will move the cursor and make
your program window "passive".
– Place the tip of the C-Pen a few millimetres before the
firstcharacter of the text. Press the C-Pen gently towards the
paper and start moving it along the text line. Try to keep a
steady line! Lift the C-Pen from the paper when you have
scanned the last character.
– The text you just scanned will instantly be inserted into
MSWord.
The text is fully editable, e.g. you can change font type and
size in MS Word to customise the text. There is a video on the
website that describes how it works in more detail.
Note that there is a small automatic trigger at the tip of the
CPen. This activates the scanning when the C-Pen is pressed
against the paper. It is important that the trigger is pressed in
during the complete scan.
The automatic trigger is shown in the picture on page 1.
Switching the C-Pen On and Off
The C-Pen is always turned on when the USB cable is connected
to a computer which is turned on.
The C-Pen will automatically turn off when you turn off the
computer, or if you disconnect the USB cable.
Tack för att du har valt C-PEN™. Med C-Pen kan du skanna text
och siffror. Exempel på program som kan ta emot data från C-
Pen är ordbehandlings-program, e-postklienter,
ekonomiprogram och webbläsare. Du kan enkelt spara tryckt
text med C-Pen från böcker, tidskrifter, dokument, fakturor
etc. Texten kan infogas precis där du vill ha den genom att