Connecting The Ac Power Cord - Christie LX505 Guía De Preparación

AC Power Cord Requirement
The AC Power Cord supplied with this projector meets the requirement for use in the country you
purchased it.
AC Power Cord for the United States and Canada:
AC Power Cord used in the United States and Canada is listed by the Underwriters
Laboratories (UL) and certified by the Canadian Standard Association (CSA).
AC Power Cord has a grounding-type AC line plug. This is a safety feature to
be sure that the plug will fit into the power outlet. Do not try to defeat this safety
feature. Should you be unable to insert the plug into the outlet, contact your
electrician.
THE SOCKET-OUTLET SHOULD BE INSTALLED NEAR THE EQUIPMENT AND EASILY
ACCESSIBLE.
Unplug the power cords of both the projector and external equipment from the AC outlet
before connecting cables.

Connecting the AC Power Cord

This projector uses nominal input voltages of 100–120 V or 200–240 V AC and it automatically
selects the correct input voltage.
CAUTION
The AC outlet must be near this equipment
and must be easily accessible.
Note:
Unplug the AC power cord when the projector
is not in use. When this projector is connected
to an outlet with the AC power cord, it is in
Stand-by mode and consumes a little electric
power.
NOTE ON THE POWER CORD
AC power cord must meet requirement of the country where you use the projector. Confirm the AC
plug type with the chart below and proper AC power cord must be used. If supplied AC power cord
does not match your AC outlet, contact your sales dealer.
Projector side
To power cord
connector on your
projector.
Setup Guide
020-000540-01 Rev. 1 (11-2010)
For the U.S.A. and Canada
Ground
To the AC outlet.
(120 V AC)
Connect the AC power cord
(supplied) to the projector.
AC outlet side
For Continental Europe
To the AC outlet.
(200 - 240 V AC)
5
For China
Ground
To the AC outlet.
(200 - 240 V AC)
LX505/605