During Operation; After Finishing Work - Cramer 82VH1000 Instrucciones De Uso

EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT LV ET
components are damaged.
For emergencies: Practice quickly opening
the fastener on the waist belt, loosening
the shoulder straps and setting down the
battery. To avoid damage, do not throw the
battery to the ground when practicing.

DURING OPERATION

The battery is equipped with a visual and
acoustic signal. Your ability to hear the
acoustic signal may be reduced when
wearing hearing protection.
The battery is carried as a backpack.
Adjusting the Harness Straps
See figure 7.
A. Pull the ends of the straps downward to
tighten the harness.
B. Lift the tabs of the adjusters to loosen
the straps.
C. Close and
fastener by pushing it together.
D. Squeeze the hooks to open the quick-
release fastener.
Putting on the shoulder strap
See figure 9.
1. Fasten and adjust the waist belt (1) so
that it rests comfortably on your hips –
thread the end of the belt through the
loop (2) – do not let the strap hang down.
2. Adjust the harness straps (3) to the
correct length.
3. Adjust chest strap (4) to correct length
and fasten it. The back padding must fit
firmly and securely against your back.
English (Original instructions)
WARNING
lock the quick-release
Connecting Battery to Power Tool
See figure 10.
Insert the adapter (1) in the power tool –
the adapter slides into the compartment
– press it down carefully until it snaps
into position. The battery and power tool
are now connected together. For further
information on switching on and operating
the power tool: see the instruction manual
of the power tool being operated with this
battery.
Acoustic Signal
The battery emits acoustic signals.
A. Short beep
„ This signal is activated by pressing the
button on the battery. Meaning: Acoustic
signal works as it should.
B. Short beep once every 10 sec
„ Meaning: The battery is less than 20%
capacity.
C. Short beep once every 2 sec
„ Meaning: Malfunction in battery.

AFTER FINISHING WORK

Disonnecting Battery to Power Tool
See figure 11.
Switch off the power tool – see also
instruction manual of the power tool being
used.
„ Depress locking levers (1) to unlock the
adapter.
„ Take the adapter (2) out of the power
tool.
The battery and power tool are now
disconnected.
Removing Harness
„ Open the quick-release fasteners on the
waist belt and chest strap.
„ Loosen the harness straps by lifting the
sliding adjusters and then take off the
battery.
4