Eaton Converge Serie Instrucciones Para La Instalación página 4

4
Remove access plate. Secure shielded cable to access plate.
Reinstall access plate pulling wiring through housing. Connect wire
feed to driver enclosure per wiring scheme on specification sheet.
6
Drywall screws should be attached to structure.
8
Level fixture and ensure fixture is at final installed height.
4
EATON
IL524011EN
Universal
Whip
Plate
Attach power and
dimming wires using
wire nuts (provided by
others)
Installation instructions
5
Attach remote box to ceiling using dry wall screws.
Apply a generous amount of joint compound to drive enclosure
flange and "feather" at least 12 inches from driver enclosure
aperture. Ensure compound has properly cured before proceeding.
7
Temporarily reinstall trim cover.
With protective wrap on fixture, feed cables through cover plate.
Rest cover plate on top of the fixture Install. Feed aircraft cables into
grippers on remote box.
9
Remove trim cover and electrical cover plate to complete wiring.
Screw flange
into frame using
Drywall screws.