Installation - Defiant DFI-5851-BK Guía De Uso Y Cuidado

Installation

1
Determining the mounting
location
NOTE: The light fixture should be mounted approximately
8 ft. (2.4 m) above the ground.
□
Determine the mounting location – wall mount
only.
□
Position the lamp heads (A) in the general
direction of the desired light coverage.
2
Removing the mounting plate
NOTE: This fixture comes with a mounting plate (D). It is
pre-assembled on the light fixture (B) for shipping.
□
Press the bottom tab (1) of the wall mounting
plate (D) and slide the mounting plate (D) from
the light body (B).
3
Installing the mounting plate
NOTE: Make sure there is enough vertical space above
the mounting plate to allow the light fixture to be mounted.
□
Place the mounting plate (D) against the wall
with the words "THIS SIDE OUT" facing away
from the wall (see illustration). Ensure the
mounting plate (D) is level. Mark the hole
locations.
□
If mounting to a wooden surface, drill two
3/32 in. holes into the mounting surface.
Install the two mounting screws (AA)
through the mounting plate (D) and into
the mounting surface.
Wall Mount
A
B
D
1
□
If mounting to wall board or brick, drill two
7/32 in. holes into the mounting surface.
Insert the wall anchors (BB) and attach the
mounting plate (D) using the two mounting
screws (AA).
AA
5
Please contact 1-866-308-3976 for further assistance.
Eave Mount
D
U T
E O
S I D
I S
T H
HOMEDEPOT.COM