LG LDF7810WW Instrucciones De Instalación página 10

I I
N N S S T T A A L L L L A A T T I I O O N N I I N N S S T T R R U U C C T T I I O O N N S S
These installation instructions are intended for use by Qualified lnstallers.
Step 10
1. If the end of the drain hose does not fit to the drain line, use an adapter (not supplied) that
must be resistant to heat and detergent and may be obtained from a plumbing shop.
2. There are 2 typical connections as shown in Fig. E & F.
① There may be other options than shown here for connection of the drain hose. The drain
connection must meet local plumbing regulations.
② The S trap spigot must be drilled out cleanly and free of obstruction to its maximum
internal diameter, if used for drainage.
③ To prevent syphoning, one of the following instruction methods must be followed:
Fig. E: Connection to Disposer or Waste Tee.
Sink
Min. 20" (508mm)
Min. 30" (770mm)
Max. 40" (1000mm)
Fig. F: Connection to Air Gap.
Sink
Rubber
Connector
Min. 20" (508mm)
Min. 30" (770mm)
Max. 40" (1000mm)
10
DRAIN LINE CONNECTION
Dishwasher
Drain Hose
Air Gap
Dishwasher
Drain Hose
Drain Requirements
�Follow local codes and
ordinances.
�Do not exceed 10 ft. (3m)
distance to drain.
�Do not connect drain lines from
other devices to the dishwasher
drain hose.