Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
If you are mounting the camera to the ceiling, use a
the bottom of the base, then guide the cables through the
bottom.
Connect the power and Ethernet cables, or just the
Ethernet cable if you are using a PoE connection.
Loosen the adjustment screw on the side of the lens
assembly, then re-tighten it after adjusting the lens
assembly to the desired vertical angle. The camera
supports from 30° to 90° of tilt.
You can also adjust the pan within a -120° to 120° range by
o
30
o
Tilt(Total 60
)
rotating it clockwise or counter-clockwise.
o
90
When you are done adjusting the camera's angle, put the
inner cover back into place.
Note: The camera has a limited range of motion; if it stops
o
120
120
o
when you are adjusting it, do not attempt to rotate or tilt
Pan(Total 240
o
)
the camera any further in that direction.
Use the screws provided to mount the camera to the
ceiling.
Re-attach the camera cover.
7
D-Link DCS-4633EV Quick Installation Guide
Publicidad
Tabla de contenido
