Residual Risks - BLACK&DECKER KS900S Traducción De Las Instrucciones Originales

The blades are retained in the compartment by a magnetic

strip. To remove a blade, press down on one end of the
blade to raise the other end, and remove.
Close the cover (3) of the saw blade storage compartment

and make sure that it is latched closed.
Warning! Close the compartment door securely before
operating the saw.
Connecting a vacuum cleaner to the tool (fig. D)
An adaptor is required to connect a vacuum cleaner or dust
extractor to the tool. The dust extraction adaptor (6) can be
purchased from your local Black & Decker retailer.
Push the adaptor (6) into the dust extraction outlet (5).

Connect the vacuum cleaner hose to the adaptor (6).


Residual risks

Additional residual risks may arise when using the tool which
may not be included in the enclosed safety warnings. These
risks can arise from misuse, prolonged use etc.
Even with the application of the relevant safety regulations
and the implementation of safety devices, certain residual
risks cannot be avoided. These include:
Injuries caused by touching any rotating/moving parts.

Injuries caused when changing any parts, blades or

accessories.
Injuries caused by prolonged use of a tool. When using

any tool for prolonged periods make sure you take
regular breaks.
Impairment of hearing.

Health hazards caused by breathing dust developed

when using your tool (example:- working with wood,
especially oak, beech and MDF).
Use
Adjusting the shoe plate for bevel cuts (fig. E and F)
Warning! Never use the tool when the shoe plate is loose or
removed.
The shoe plate (7) can be set to a left or right bevel angle of
up to 45°.
Pull the shoe plate locking lever (4) outwards to unlock the

shoe plate (7) from the 0 deg position (fig. E).
Pull the shoe plate (7) forward and set the required bevel

15°, 30° and 45° indicated in the bevel angle window.
Push the shoe plate locking lever (4) back towards the saw

to lock the shoe plate (7).
To reset the shoe plate (7) for straight cuts:
Pull the shoe plate locking lever (4) outwards to unlock the

shoe plate (7).
Set the shoe plate (7) to an angle of 0° and push the shoe

plate backwards.
Push the shoe plate locking lever (4) back towards the saw

to lock the shoe plate (7).
ENGLISH
9