1.2
NOTE: A second person will be required
to help guide the bed liner side wall
under the bed rail.
Lift the center of the bed liner floor
in order to slide the side wall down.
Be sure that the front of the bed liner
is above the rail.
After the bed liner is in the correct
position, lift the floor slightly to
insert the top edge of the liner
under the bed rail.
Then push the bed liner floor
down flat to the truck bed floor.
NOTE: the floor will relax and sit
totally flat after 20-30 mins.
1.5 INSTALLATION COMPLETION Installer to fold this I-Sheet and place it in the vehicle's glove box.
SAFETY TIPS
Improper installation of the liner may cause it to be loose and leave the vehicle. Make sure the liner
1.
is secure before each trip.
Rain, snow, frost, ice, mud can make the liner slippery. Extra caution is required when moving on a
2.
potentially slippery surface.
Do not transport pets on the liner.
3.
WARRANTY
This product is warrantied to be free from defects in material and workmanship for the lesser of
3 years or 36,000 miles from the retail date of purchase. Warranty is nontransferable and
applies to the original purchaser of the bed cover product only.
The manufacturer reserves the right to determine whether a product needs to be repaired or
replaced. No labor or service allowance is given or implied. The warranty does not cover any
damage to the product caused by accident, collision, alteration, modification, customer abuse or
neglect, off-road driving, commercial use, theft, vandalism, natural disaster or loss of product or
parts. The warranty is void if the installation instructions or operating instructions are not
followed. The manufacturer assumes no liability for injury, loss, incidental or consequential
damages. The manufacturer reserves the right to substitute an entire replacement system or
provide other remedies than those listed in this warranty for discontinued products or other
reasons.
Please feel free to contact us should you require any assistance with your bed cover. Phone:
833-204-2606. Email: FCACare@truck-hero.com.
August, 15 2018
www.mopar.com
1.3
Insert the scrivets.
Install the Cover-Anchor Tie-downs.
1.4
2
NOTE:
Soapy water
can be used
to facilitate
Cover-Anchor
Tie-down
installation.
K6862673AB