Initial Operation; Storage / Care; Disposal / Recycling - Brill PowerAccu 24 Manual Del Usuario

These instructions also contain
hints on use, service and main-
tenance.
GB

5. Initial operation

5.1. Making sure your
PowerAccu set is complete
The original packaging
includes the following parts:
– PowerAccu 24 Volt
– Charging Unit LG 24
– Operating instructions
with safety instructions
– Index of service centres
5.2. Charging of PowerAccu
For technical reasons the Accu
is not charged. Consequently,
the unit needs to be charged
before initial operation ( Fig.1,
Pos. 2 ).
Only the following Brill chargers
should be used for this purpose :
Charging Unit LG 24 (enclosed)
Charging time: approx.
24 hours for the initial charge.
Afterwards, 12 - 24 hours de-
pending on the state of charge.
Rapid charging unit (accessory)
Art. No. 65038
Charging time: approx. 2 hours
The PowerAccu reaches its full
capacity only after numerous
16
Attention ! Risk of injury !
A
Only use the PowerAccu
as a power source for Brill
24 Volt devices.
(approx. 5) charging/discharg-
ing processes.
The PowerAccu must
A
only be charged using
the above mentioned charging
unit, since only in this way an
optimal technical coordination
between Accu and charging
unit can be guaranteed.
The use of other charging units
can lead to damage and injuries.
The use of other charging units
makes all claims for compen-
sation null and void and re-
leases the manufacturer from
all guarantee services.
5.3. Initial Operation
Figure 2
Your PowerAccu has an adjust-
able harness and a belt clip.
Hang the harness over your
shoulder and secure the Power-
Accu to your belt using the clip.
Plug the accu clip of the tool
you are using into the facility
of the PowerAccu 1 .
To disconnect your tool, pull
the accu clip out of the facility
1 .

6. Storage / Care

The PowerAccu should be stored
at a dry, elevated, frost-free,
locked up place, where children
have no access. Avoid direct
sunlight.
Never store while still attached
to a tool, this prevents misuse
and accidents.
Make sure the surface and
the contacts of the PowerAccu
always are clean and dry

7. Disposal / Recycling

These Accus
Ni-Cd
contain
nickel/cad-
mium cells.
After their lifetime have expired,
they may not be disposed of
as normal house rubbish, but
must be disposed of properly.
When working with the tool
the PowerAccu heats up; this is
normal and does not affect its
performance.
before connecting the charging
unit. When dirty clean them
with a soft, dry rag; never use
running water.
If you do not use the PowerAccu
for long periods of time, please
charge it completely before
storing. Since a gradual self-
discharge occurs, charge the
PowerAccu completely before
initial use after longer periods
of storage.
Please return the Accus to a
dealer who keeps the PowerAccu
24 Volt system from Brill or
send them directly to one of the
Brill Service Centres listed on
the rear.
17
GB