Cleaning And Maintenance - AmazonBasics Madison B07J5HRDC3 Manual De Instrucciones

Installation
Step 8: Install Strike
1. Close the door to make the horizontal center line of the strike.
2. Measure one-half of the door thickness starting from the door stop and mark the vertical center
line of strike. Drill a 1" (25 mm) hole that is 1/2" (13 mm) deep at intersection of horizontal and
vertical line of the strike. Match the screw holes on the strike with the center lines on the jamb.
Mark an outline and chisel 1/16" (1.6 mm) deep for the strike.
3. Install the strike and tighten the screws.

Cleaning and Maintenance

• Check the components regularly to make sure all screws and bolts are tightened.
12