AmazonBasics Madison B07J5HRDC3 Manual De Instrucciones página 8

Installation
Step 5: Install Latch
1. Insert the latch into the hole, and keep it parallel to the door face. Mark the outline of the face
plate and remove the latch.
2. Chisel 1/8" (3 mm) deep or until the face plate is flush with the door edge.
3. Insert latch and tighten screws.
Optional
• It is not necessary to chisel the door edge for the faceplate installation if you use the drive-in
latch. You may install it into the edge bore directly, but make sure the bevel is facing the outside
assembly.
8
Optional