Using The Subwoofer; Pre-Adjusting The Subwoofer Volume - Yamaha YST-FSW100 Manual De Instrucciones

Using the subwoofer

Subwoofer
top panel
Subwoofer rear panel
( For Asia and General models)
4
VOLTAGE
SELECTOR
220V-240V 110V-120V
INPUT
INPUT INPUT
VOLUME
1 Power indicator
Lights up GREEN when the POWER switch
(2) is turned ON; turns off when the POWER
switch is turned OFF.
2 POWER switch
Press this switch to the ON position to turn on
the power to the subwoofer. When the power of
the subwoofer is on, the power indicator (1) on
the top panel lights up green. Press this switch
again to set it to the OFF position to turn off the
power of the subwoofer.
3 VOLUME control
Adjusts the volume level. Turn the control
clockwise to increase the volume, and
counterclockwise to decrease the volume.
4 INPUT terminal
Input terminal for line level signals from the
amplifier.
For Asia and General models
VOLTAGE SELECTOR
See page 3 for more details.
4
3
2
VOLUME
POWER
1
SUBWOOFER SYSTEM YST-FSW100
VOLUME POWER
Pre-adjusting the subwoofer
volume
Before you use the subwoofer, first adjust the
volume balance between the subwoofer and the
front speakers by following the procedure below.
1.
Set the VOLUME control to minimum (0).
2.
Turn on the power to all other components.
3.
Press the POWER switch to the ON position.
The power indicator on the top panel lights up
green.
4.
Play a source that contains low-frequency
sounds. Adjust the amplifier's volume control to
the desired listening level.
5.
Increase the volume gradually to adjust the
volume balance between the subwoofer and the
front speakers. To enjoy natural bass sound,
keep the subwoofer volume at a level where it is
barely distinguishable from other speakers.
6.
Adjust the volume of the entire sound system
using the amplifier's volume control.
Note: It is recommended to set the
VOLUME control about in the middle
position when using in a multi channel
home theater system.
VOLUME