Tabla De Contenido - Invacare RELIANT 100 Manual De Utilización

Our INVACARE range of mobile lifters is one of the most comprehensive in Europe. It covers a wide
spectrum of user needs from a basic, compact hydraulic model to a high-performance heavy-duty
electrically operated model.
All our lifters are built to the most stringent high-quality standards where SAFETY and RELIABILITY are
the overriding criteria. They are easy to operate and user-friendly, both for the patient and the attendant.
Please read this manual carefully before you start to use the lifter. It contains useful tips and information
on safety, operation and maintenance.
In the event of any problems or queries, do not hesitate to contact the local INVACARE dealer who will
be at your service for advice and assistance.
This manual is subject to change without prior notice in the interest of product improvement.
GENERAL SPECIFICATION
ASSEMBLY
OPERATING INSTRUCTIONS
Adjustment of Chassis Width
Brakes
Moving the Lifter
Attaching Slings
Raising/Lowering
Reliant 100 & 200
Reliant 150 & 250
BATTERY CHARGING
MAINTENANCE
General
Lubrication
Chassis Assembly
Chassis Adjustment Mechanism
Wear or Damage
Cleaning
TROUBLESHOOTING
WARRANTY
ASSEMBLY
The Lifter in the Invacare range are designed for easy assembly. The only tools required are an adjustable
spanner and a 5mm Allan key.
CAUTION
TAKE THE UPMOST CARE WHEN LIFTING COMPONENTS DURING ASSEMBLY
ALWAYS REMEMBER TO ADOPT THE CORRECT LIFTING POSITION. ASSEMBLED
LIFTER WEIGHTS ARE AS FOLLOWS:
REL100-32KG, REL150-34KG, REL200-34KG, REL250-36KG.
To Assemble
1. Remove all parts from the carton.
2. Place the chassis assembly on the floor and apply the brakes, by pressing on the round pedal located on
both rear castors.
3. For increased stability, widen the chassis legs by pressing down the r/h pedal at the back of the Chassis.
4. Insert the Mast and Jib/actuator assemblies into the Socket located in the chassis.
5. In the Plastic Bag supplied, you will find an 85mm long Screw, Handknob and a Hexagon Wrench.
6. From the rear of the Lifter insert the 85mm long Screw through the location holes in Chassis and Mast
ensuring the Threaded end protrudes through to the inside of the Lifter. Using the Hexagon Wrench
to secure Tighten Handknob.
7. Electric Models connect the Remote Control Cable to the Control Module.
RELIANT 100/150/200/250
USER GUIDE
INTRODUCTION
CONTENTS
Page
1
1
2
2
2
2
2
2
2
3
3
3
3
3
3
4
4
4
4
BACK COVER
1